Red Ice 613 thermal compound is a 1K thermal compound from Red Ice. Short answer: we dispense it with PRO-CP20 + PDP-1000HFS.
Recommended: PRO-CP20 + PDP-1000HFS, fed from a 5 gal pail.
Material at a glance
| Manufacturer | Red Ice |
|---|---|
| Type | 1K thermal compound |
From Dispense Robotics test records and the manufacturer's published data. Always work from the current technical data sheet.
How we dispense it
We have run Red Ice 613 thermal compound on Dispense Robotics equipment. Our recommendation is PRO-CP20 + PDP-1000HFS, fed from a 5 gal pail. Pump size still depends on your shot or bead size and cycle time, so send us those and we'll confirm.
- Abrasion: the ceramic filler that carries the heat wears pumps out. We use tungsten carbide rotors and wear-resistant stators and run the pump slowly, at 8 to 12 rpm, for long wear life.
- Feed: thick pastes don't flow to a pump on their own. Above cartridge volumes, a follower plate pushes the material out of the pail and keeps air out.
See our PCP progressive cavity pumps, or use the pump configurator.
Frequently asked questions
What pump should I use to dispense Red Ice 613 thermal compound?
We have run Red Ice 613 thermal compound on Dispense Robotics equipment. Pump size depends on your shot or bead size and cycle time; send us those and we will size it.
Can Red Ice 613 thermal compound be fed from pails instead of cartridges?
Cartridges suit lab and low volume. Above that, a follower-plate pail pump feeds the metering pump directly, which cuts container changes and waste.
Does Red Ice 613 thermal compound need mixing?
No. It is a single-component material, so there is no mixer and no ratio to hold. The job is accurate, repeatable volumetric metering, which is what a progressive cavity pump does.
Will Red Ice 613 thermal compound wear out the pump?
Thermally conductive fillers are abrasive. With tungsten carbide rotors, wear-resistant stators and pump speeds of 8 to 12 rpm, stators typically last 6 to 12 months and rotors up to 24 months, and a pump rebuild takes under an hour.
Talk it through with us
Running Red Ice 613 thermal compound, or about to? Send us the technical data sheet, your bead or shot size and your cycle time, and we'll recommend a pump and feed system. We can run an application test on your material before you buy. Contact us
Related materials
- BERGQUIST TGR 4000 (formerly TIC 4000) · Henkel Bergquist, thermal grease
- CoolTherm TC-404 · Parker LORD, thermal grease
- DOWSIL TC-5622 Thermally Conductive Compound · Dow, thermal grease
- SilCool TIG3500H · Momentive, thermal grease
- SEMICOSIL Paste 40 TC · Wacker, thermal grease
- WACKER Paste P12 · Wacker, thermal grease
All thermal interface materials · Materials we've dispensed
Red Ice 613 thermal compound is a trademark of Red Ice or its affiliates. Dispense Robotics is not affiliated with the manufacturer; the name is used to describe the material our equipment dispenses.